The N composition

in the SiCN layer used in the SLs was about 18%. The optical bandgaps were determined from optical transmittance measurements of the films that were grown on quartz substrate by applying the Tauc model [19]. The optical bandgaps of the SiCN and SiC layers in the SLs were estimated to be around 2.6 and 2.2 eV, respectively. The electron Androgen Receptor pathway Antagonists densities of the SiCN and SiC layers were measured at room temperature AG-881 solubility dmso using the Hall measurement system and were determined to be 4 × 1018 and 2 × 1017 cm−3, respectively. The electron density of the SiCN layer was 20 times higher than that of the SiC layer. Figure  1b shows the HRTEM image of the Si NC LED with 5.5 periods of SiCN/SiC SLs. The interfaces between the SiCN and SiC layers consisting the SLs were flat and abrupt, suggesting that the structural

property of the 5.5 periods of SiCN/SiC SLs was quite good. Figure  1c,d shows the SEM images of the surfaces of the SiC and SiCN layers, respectively. As shown in Figure  1c,d, the surfaces of the SiC and SiCN layers were very smooth. Figure 1 Schematic illustration,HRTEM image,and SEM images. (a) A schematic illustration of the Si NC LED with 5.5 periods of SiCN/SiC SLs. (b) An HRTEM image of Si NC LED with 5.5 periods of SiCN/SiC SLs. The interfaces between each layer of Si NC LED with the SLs were flat and abrupt. (c) SEM image of the SiC layer surface. (d) SEM image of the SiCN layer surface. The current–voltage (I V) curves of Si NC LED with and without 5.5 periods of SiCN/SiC SLs measured at room PRIMA-1MET solubility dmso temperature, respectively, are shown in Figure  2a. The I V curve of Si NC LED with 5.5 periods of SiCN/SiC Proton pump inhibitor SLs was better than that of Si NC LED without the

SLs, as can be clearly seen in Figure  2a. In order to investigate the effect of SLs on the electrical property of Si NC LED, the typical on-series resistance (R S ) of Si NC LEDs with and without 5.5 periods of SiCN/SiC SLs was calculated using the measured I V curves shown in Figure  2a. The R S was calculated from the diode relation of a p-n junction. When the R S contributes to device behavior, the diode equation can be written as , where I 0 is the prefactor, V is the measured voltage, and n is the ideality factor [20]. This equation can be rewritten as I(dV/dI) = IR S  + nkT/q, indicating that R S and n can be extracted from the slope and y-axis intercept of this equation. The R S values were calculated to be 126 and 79 Ω, respectively, as shown in Figure  2b. The R S for Si NC LED with 5.5 periods of SiCN/SiC SLs significantly decreased as compared with that of Si NC LED without 5.5 periods of SiCN/SiC SLs. Figure 2 I-V curves and series resistances of Si NC LEDs. (a) I-V curves of Si NC LEDs with and without 5.5 periods of SiCN/SiC SLs, respectively.