However, forced expiratory volume in one second (FEV1) measured by spirometry, the standard measurement of airflow limitation, has only a weak relationship with these outcomes in COPD. Recently, in addition to spirometry, impulse oscillometry (IOS) measuring lung resistance (R) and reactance (X) is increasingly being used to assess pulmonary functional impairment.\n\nMethods: We aimed to identify

relationships between IOS measurements and patient-reported outcomes in 65 outpatients with stable COPD. We performed pulmonary function testing, IOS, high-resolution computed tomography (CT), and assessment of health status using the St. George’s Respiratory Questionnaire (SGRQ), dyspnea using the Medical Research Council (MRC) scale and psychological status using the Hospital Anxiety and Depression IPI-145 ic106 Scale (HADS). We then investigated the relationships between these parameters. For the IOS measurements, we used lung resistance at 5 and 20 Hz (R5 and R20, respectively) and reactance at 5 Hz (X5). Because R5 and R20 are regarded as reflecting total and proximal airway resistance, respectively, the fall Quizartinib in resistance from R5 to R20 (R5-R20) was used as a surrogate for the resistance of peripheral airways. X5 was also considered to represent peripheral airway abnormalities.\n\nResults: R5-R20 and X5 were significantly

correlated with the SGRQ and the MRC. These correlation coefficients were greater than when using other objective measurements of pulmonary function, R20 on the IOS and CT instead of R5-R20 and X5. Multiple regression analyses showed that R5-R20 or X5 most significantly accounted for the SGRQ and MRC scores.\n\nConclusions: IOS measurements, especially indices of peripheral airway function, are significantly correlated with health status and dyspnea in patients with COPD. Therefore, in addition to its simplicity and non-invasiveness, IOS may be a useful clinical tool not only for detecting pulmonary functional impairment, but also to some extent at least estimating the patient’s quality

of daily life and well-being.”
“Objective: To determine the effect of a commercially available disinfectant solution (Perform ID) on the dimensional stability of two different commercially available alginate impression materials.\n\nMethods: Linear changes in standardized impression samples (1.5 mm & 3.0 mm thickness) made in selleck inhibitor two commercial alginates were recorded at 5 minute intervals, over a period of an hour after immersion in a disinfectant. The alginate impression samples were prepared placing the alginate mixes into a wax mould. After the material had set, each of the samples was removed from the mould. It was then placed in a Polytetraflouroethylene (PTFE) trough before measuring the dimensional changes using a Chesterman travelling microscope.\n\nResults: 3mm Blue Print Cremix showed greater shrinkage than 3mm Hydrogum. While, 1.5mm Hydrogum appeared to have uniformly greater shrinkage as compared to 1.5mm Blue Print Cremix.