It was cooled and weighed. The percentage of ash with reference to the air dried leaves was calculated as total ash value. The ash obtained was boiled with 25 ml of 2 N HCl for 5 min. The insoluble matter was collected in a Gooch crucible, washed with hot H2O, ignited and weighed. The

percentage of acid insoluble ash with reference to air dried crude drug was calculated. The ash obtained was boiled with 25 ml see more of Distilled water for 5 min. The soluble matter was collected in a Gooch crucible, washed with hot H2O, ignited and weighed. The percentage of water soluble ash with reference to air dried crude drug was calculated. The extracts obtained by exhausting crude drugs are indicative of approximate measure of certain chemical constituents. Various solvents are used for the determination of extractives because of the diversity in chemical nature and properties of contents of the drugs. The solvents used for extraction is in position to dissolve appreciable quantities of substances Panobinostat supplier desired. The following procedure was used to find out the extractive values for the plant material. 5 g air dried coarsely powdered leaf materials were macerated separately with 100 ml of each solvent (Petroleum

ether, Chloroform, Methanol and water) in closed container for 24 h, it was shaken frequently during the first 6 h and allowed to stand for 18 h, and then filtered, 25 ml of the filtrate was taken from each flask and evaporated to dryness in a tarred flat-bottomed shallow dish, dried at 105 °C and weighed. The percentages of different soluble extractive values were calculated with reference to the air dried powder. 1.5 g of the powdered drug was weighed into weighed flat and thin porcelain dish. It was dried in the oven at 100 °C and cooled in a desiccator. The loss in weight not is recorded as moisture. 500 mg of dried powder of leaves

of D. patulus were Soxhlet extracted with 10 l of 85% methanol for 48 h. Then the extract was collected, filtered and the solvent was evaporated under vacuum in a rotary evaporator. The approximate yield of extract was 13.25% (66.25 g) and stored in refrigerator at −20 °C before use. Stigmasterol (purity 95%), were purchased from Sigma Alrich. The solvent acetonitrile with HPLC grade were procured from E. Merck Mumbai, India. All water was ultra-pure (distilled and de-ionised). A HPLC unit comprising of two LC-8A preparative pumps connected with a SPD-M20A PDA detector (Photo Diode Array detector) which has ability to scan from 200 to 800 nm and a system controller CBM-20A. The system is equipped with LC solution software version 1.2, which also manages the evaluation of datas collected. C18 (250 × 4.6 mm SS, 5u particle size) column was used for the study.