Transverse strengths of white and pink acetal resin could not be calculated in this study, as white and pink acetal resin specimens did not break at the maximum applied force in the three-point bending test. Flexural strength of acetal resin was found to be within the ISO specification limits. As the water storage time increased, the deflection values of PMMA showed no significant difference (p > 0.05). Both the white and pink acetal resin

showed significant increase in deflection as the water storage time was increased from 50 hours to 180 days (p < 0.05). Conclusion: The results of this study indicated that transverse strength values of PMMA were within the ISO specification limit. Water storage time (50 hours, 30, 60,

and 180 days) had no statistically significant effect on the transverse strength and deflection of PMMA. Acetal resin suffered from permanent deformation, but did not break in the three-point bending test. Acetal check details resin showed significant increase in deflection as the water storage time was increased from 50 hours to 180 days. All materials tested demonstrated deflection values in compliance with ISO specification No 1567. “
“The aim of this study was to investigate the effect of accelerated light aging on bond strength of a silicone elastomer to three types of denture resin. A total of 60 single lap joint specimens were fabricated with auto-, heat-, and photopolymerized (n = 20) resins. EGFR targets An addition-type silicone elastomer (Episil-E) was bonded to resins treated with the ioxilan same primer (A330-G). Thirty specimens served as controls and were tested after 24 hours, and the remaining were aged under accelerated exposure to daylight for 546 hours (irradiance 765 W/m2). Lap shear joint tests were performed to evaluate bond strength at 50 mm/min crosshead speed. Two-way ANOVA and Tukey’s test were carried out to detect statistical significance (p < 0.05). ANOVA showed that the main effect of light aging was the most important factor determining the shear bond strength. The mean bond strength values ranged from 0.096 to 0.136 MPa. The highest

values were recorded for auto- (0.131 MPa) and photopolymerized (0.136 MPa) resins after aging. Accelerated light aging for 546 hours affects the bond strength of an addition-type silicone elastomer to three different denture resins. The bond strength significantly increased after aging for photo- and autopolymerized resins. All the bonds failed adhesively. “
“The CAD/CAM technology associated with rapid prototyping (RP) is already widely used in the fabrication of all-ceramic fixed prostheses and in the biomedical area; however, the use of this technology for the manufacture of metal frames for removable dentures is new. This work reports the results of a literature review conducted on the use of CAD/CAM and RP in the manufacture of removable partial dentures.