X flow. NSC 640488 All materials were applied according to manufacturers’ instructions and were all photopolymerized (Bluephase LED unit, Ivoclar Vivadent, 40s). After 24 hours, roots were transversally cut into 9 slices 1 mm thick from the coronal to apical extremes, three
corresponding to each root third. Then, VHNs were recorded (100gf, 30 s) on the resin luting materials along the adhesive interface in all sections. Data were analyzed by two-way ANOVA and SNK tests (alpha=0.05).
Results: A significant influence on microhardness of resin luting material in their respective shades (p<0.001), root third (p<0.001) and interactions between them was detected (p<0.001). RelyX Unicem cement showed the highest microhardness values and Calibra the lowest, regardless of the shade selected. All resin luting materials tested exhibited a significantly higher microhardness in the cervical third.
Conclusions: Microhardness of resin luting agents tested inside the canal is dependent on material brand and resin cement shade
seems to be a less relevant factor. Microhardness decreased along the root canal, regardless of the shade selected.”
“The analysis of the sagittal balance is important for the understanding of the lumbopelvic biomechanics. Results from previous studies documented the correlation between sacro-pelvic orientation and AZD1208 solubility dmso lumbar lordosis and a uniqueness of spino-pelvic alignment in an individual person. This study was subjected to determine the lumbopelvic orientation using pelvic radius measurement
technique. The standing lateral radiographs in a standardized standing position were taken from 100 healthy volunteers. The measurements which included hip axis (HA), pelvic radius (PR), pelvic angle (PA), pelvic morphology (PR-S1), sacral translation distance (HA-S1), total lumbosacral lordosis (T12-S1), total lumbopelvic lordosis (PR-T12) and regional lumbopelvic lordosis angles (PR-L2, PR-L4 and PR-L5) were carried out with two independent observers. The relationships between the parameters were as follows. PR-S1 demonstrated positive correlation to regional lumbopelvic lordosis and revealed negative correlation to T12-S1. PA showed negative correlation to PR-S1 selleck compound and regional lumbopelvic lordosis, but revealed positive correlation to HA-S1. T12-S1 was significantly increased when PR-S1 was lesser than average (35 degrees-45 degrees) and was significantly decreased when PR-S1 was above the average. PR-L4 and PR-L5 were significantly reduced when PR-S1 was smaller than average and only PR-L5 was significantly increased when PR-S1 was above the average. In conclusion, this present study supports that lumbar spine and pelvis work together in order to maintain lumbopelvic balance.”
“It was shown by quantum-chemical method B3LYP/6-311++G(df,p) that in the autocatalytic reaction the molecules of methyl carbamate formed prereaction complexes with the monomer and dimer of methanol.